Then, use your other hand to turn the printer on. Label Creation Word, or with different word processors, but the basic principles will be the same. Click the Calibrate button to have Toro feed some of the label stock through and re-adjust its internal sensors. If you are still unable to print, please contact our support team for help. It should unroll to feed beneath the white roller, and slide smoothly between the green guides as they hold it centered. Just from there select the Options Tab. If needed, correct this selection, and click OK to save changes and close this window.
|Date Added:||27 June 2013|
|File Size:||42.37 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
DuraSuite Labeling Software is included with: All trademarks are the property of their respective owners.
The printer has finished following the instructions that it received. How to Create Floor Marking Corners. The printer is not seeing that mark or gap — possibly, not even looking for it.
The printer is looking to cut on a mark, but can’t find it.
Go back to your label and try printing again. Usually, this is because the print head mechanism is not latched down all the way. We usually recommend cleaning the printer after every two or three rolls of label stock; now may be a good time. Getting Started with DuraSuite. If this setting was already correct, and you are using a compatible ribbon, then click the Calibrate button to have Toro feed some of the label stock through and re-adjust its internal sensors.
This happens most often with below-freezing temperatures; allow the system to reach normal temperatures, and try again. The label stock should roll forward, underneath the white roller, between the two movable guides at the back of the print head, through the green C-shaped sensor, and finally forward over the black rubber roller in front.
Add to watch list Remove from watch list.
How to Clean DuraLabel Kodiak. Graphic Products P. Right-click on the entry for your DuraLabel printer, and choose Printing Preferences. Seller does not offer returns. If the problem continues without anything coming out of the printer, please contact our support team for help. Check the Supply Loading Turn off the printer using the switch in the back, near the black power cord, and open the printer as if you were going to change all the supplies.
Label Opening 4, pg.
Durqlabel can watch a video of the loading process for clarification, if you’d like. A dialog box will appear regarding Hardware Installation, click Continue Anyway. You can change the automatic cutter settings without going back into the printer driver. Use the arrow keys here to set the time and date accurately.
Graphic Products DuraLabel 4 TTP Label Thermal Transfer Printer
Go to the Stock tab, and look at the Duralabe drop-down menu. Then, try printing your label once more. Remove the ribbon take-up roll in front so that you can see the metal print head. The Toro should be aligning itself to a gap or mark, but instead is only printing and cutting based on the label length.
Low Cost DuraLabel 4 TTP Vinyl Tape, Quality Vinyl Label Tape for DuraLabel 4 TTP Label Printers
An item that has been used previously. You may need to re-tape the ribbon onto this take-up roller. Subject to credit approval. It should be set to Thermal Transfer.
FREE: DuraLabel 4 TTP Thermal Transfer Label & Sign Printer Printer – Preowned
Keep holding the button, and xuralabel the light on top of the printer. Turn off the printer using the power switch in the back, near the black power cord. The light will flash briefly, then blink in a pattern: